Steel 10 for balconies and mezzanines
With Steel 10, the modules contained in the HF0210 kit allow easy and fast installation of a balustrade on flat surfaces by building sections made up of 4 load-bearing structural parts (2 vertical and 2 horizontal) interspersed with 11 vertical square cross-section tubes.
The joints, complete with white rivets for removal-proof fixing, allow installation angles from 90° to 270° as well as cutting the structural parts and joining the modules during installation, modifying both the height and the length of the balustrade.
Ideal for balconies and mezzanines, because installable both indoors and outdoors.
The design of Steel10 has carefully taken child safety into consideration thanks to the reduced interspaces and the vertical configuration.
The materials used in all the parts and finishes allow installation both indoors and outdoors, also in the presence of sea salt, urban pollution and sunrays.
All the kit are in matt white RAL 9010 Fe360 steel.
- Installation environment:
Steel 10 is the railing and handrail solution for indoor and outdoor staircases. If the install are outdoor please follow all maintenance advice meticulously.The Steel10 balustrade can only installed horizontally, not sloping.
Indoor useLow-aggressive outdoorAggressive outdoor
- Railing resistance:
The structural strength can be doubled by halving the distance between the balusters. The structural strength tests to verify compliance with the provisions laid down in Ministerial Decree dated 14/01/2008 and the requirements according to the UNI EN 1991-1-1 (EUROCODE 1) standards have been conducted in Italy at the Giordano Institute laboratories, SIT / SINCERT accredited and authorised by the Ministry for Infrastructures to conduct tests and issue test certificates for the construction materials. The test certificates can be viewed at the link: Railing certification
In order to be sure that your installation complies with the standards, find out which local and national regulations apply to the intended use (private, office, shops, etc.). Carry out the installation in a workmanlike manner using appropriate tools.
Clean with a soft, damp cloth, avoiding the use of any solvent or abrasive material, and dry carefully to remove any limestone deposits left by the water. We advise cleaning with normal automotive cleaning products available on the market at least once a year for the Steel10 and Steel30 railings. For installations in areas with high levels of environmental or urban pollution or close to the sea, clean thoroughly and accurately with suitable products (see above) every 4-6 months, or as soon as stains can be seen on the surface of the items.
|Use||Balustrade railing module for indoor and outdoor flat surfaces.|
|Finishing||Matt White-painted (RAL 9010).|
|Dimensions||Each HF0210 kit contains everything you need for a balustrade of 150cm in length and 110cm in height. Rectangular cross-section baluster (cut between 5 and 110cm): 40x20x2 mm. Sections (cut between 16 and 150cm): 40x20x2 mm. Tubes: 12x12x1 mm.|
|Structure||Each kit allows building a section made up of 4 load-bearing structural parts (2 vertical and 2 horizontal) interspersed with 11 vertical square cross-section tubes. PA6 technopolymer fixings and joints are included, adjustable with straight sections or v|
|Warning||The kits do not contain the screws and plugs for floor and wall fixing.|
All spiral staircases whether new or replacement need to comply with the UK building regulations - there are also special requirements for Spiral Stairs and Space Saver stairs which are detailed in BS5395-2, the British Standard which applies to staircases of this type, BS5395-2 is referred to in building regulations as the general standard for spiral staircases and helical stairs.